Where would you normally use this stainless steel handrail fitting ?
As part of the Designer Rail handrail on a staircase when needing to terminate the handrail to comply with Australian standard AS1428.1. The 180 degree bend already comes with an end cap fitted to finish it off.
What is it made out of ?
316 grade Stainless Steel in a Satin finish.
What are the important dimensions ?
The outside diameter is 43mm, which is the same as the diameter of the handrail.
Can it be used for exterior application ?
As it is 316 grade Stainless Steel, it is more than suitable for use outside.
How do you fix it to the handrail ?
Using either the Designer Rail drilling jig or going free-hand, attach the Designer Rail plastic connector to the end of the handrail and then fit the end cap onto it with a small amount of suitable adhesive.
Due to the length and weight of this product we would recommend at least 1 handrail bracket is used to support this fitting so as not to cause too much stress on where it joins to the handrail.
NOTE : This product is NOT supplied with the plastic connector used to join the fitting to the end of the timber handrail. This must be ordered separately.
1 plastic connector is required for this fitting.
*** IMPORTANT - PLEASE READ *** Click this link
to view the connector required.
Please Read Before Ordering : To join this fitting to the 43mm handrail, you will need to order the IF131 Designer Rail Plastic Connector. One of these connectors are required for this fitting. Click this link to view the connector required.