Where would you use a hydraulic wire swager ?
When doing wire cable balustrade using hydraulically swaged fittings, this tool will allow you to flatten the ends of the fittings so that the wire (3.2mm
or 4mm) is securely held in place.
Please be warned that attempting to use a pair a plyers or something similar is NOT recommended, as the pressure required to flatten the fixings is far
greater than can be applied by hand.
This tool has a maximum output of 8 tonne; and is supplied in a handy plastic carry case along with a compete set of dies that apart from balustrading
can also be used for many other applications.
If using hydraulically swaged fittings for 3.2mm wire, we recommend using the dies marked with a 6.
If using hydraulically swaged fittings for 4.0mm wire, we recommend using the dies marked with a 10.
Extra sets of dies can be purchased if they distort over time.
If you have any questions, please contact us prior to ordering.